Mobotix MX-KEYPAD1-EXT-SV Informações Técnicas descarregar pdf (Página 101)

101/148

Installing The T24-DoorMaster

www.mobotix.com • [email protected]

Preparing The In-Wall Socket (Solid Wall)

A in-wall socket must usually be ﬁtted ﬁrst. Make sure that the socket you use is as ﬂush

with the wall as possible to ensure proper installation. Also make sure that the socket

and T24-DoorMaster are aligned correctly.

After connecting the cables, there are two ways to attach the door opener board to the

in-wall socket:

1. Secure the housing and board directly to the socket by fastening two small screws in

the a and b positions (see ﬁg.) However, this requires that the socket is properly aligned

in the wall. Thanks to the elongated shape of the screw holes, it is possible to make

small adjustments to the left and to the right when tightening the screws.

2. Use four or two Torx screws/screw anchors (diagonally opposite one another) to

tightly screw the housing and board to the wall. We recommend using this procedure

if the installed in-wall socket is not properly aligned or is not ﬂush with the wall,

or if the T24-DoorMaster could easily be pulled out together with the in-wall socket.

The in-wall socket used must be ﬂush with the wall.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 149 150

Sem comentários

Mobotix MX-KEYPAD1-EXT-SV Informações Técnicas Página 101