Mobotix S15 Especificações descarregar pdf (Página 153)

153/164

Special Case: Setting Up an S15 FlexMount as a Door Station

www.mobotix.com • [email protected]

Notes

•

In order to be able to use an S15 as door station, please make sure that the camera

is running software release 4.1.9 or higher.

•

Only the new MX-DoorMaster (article no. MX-Door2-INT-PW) can be used together

with the S15! The predecessor T24-DoorMaster (article no. MX-Door1-INT-PW)

cannot

be used with an S15.

For installing and wiring these components, follow the same steps as for the MOBOTIX

IP Video Door Station. You can ﬁnd detailed information about wiring as well as the maxi

mum cable lengths in the

IP Video Door Station System Manual Part1

and in the docu-

ments

BellRFID Quick Installation

KeypadRFID Quick Installation

and

MX-232-IO-Box Quick

Installation

www.mobotix.com> Support> Manuals).

3.7.2 Execute Auto Conﬁguration

Just like with the IP Video Door Station, you can use the camera’s Auto Conﬁguration to

set up the S15 as a door station without a computer. Once all required components have

been wired and connected to the S15, you can launch the auto conﬁguration to set up

the S15 as a door station.

Starting the Auto Conﬁguration

Remove the power supply of the camera, then restore the power supply. The camera will

execute a reboot and the LEDs next to the camera keys are lighting up green and red.

2. Press both keys on the camera front (R/L) and keep them pressed until the LEDs are

ﬂashing several times. Release the keys.

Setting Up a KeypadRFID Module

With this module, the end of the auto conﬁguration is signaled as follows– number keys

are ﬂashing white, the ESC key is ﬂashing red and the OK key is ﬂashing blue.

1. Enter the Super PIN you want to use and add an admin card.

2. Train the user cards as required.

You can ﬁnd detailed information on setting up the KeypadRFID module in the

IP Video Door Station System Manual Part2

Section2.2, «Setting up the Keypad»

Setting Up a BellRFID Module

With this module, the end of the auto conﬁguration is signaled as follows– the blue and

green status LEDs are ﬂashing and the OK button is red.

1. Enter the Super PIN you want to use on the keypad insert and press OK. This button

turns green and the letter button lights up red.

2. You can select the applicable bell button set by pressing any one of the button

contacts in the center.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 163 164

Comentários a estes Manuais

Sem comentários

Mobotix S15 Especificações Página 153

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras de segurança Mobotix S15