Mobotix S15 Especificações descarregar pdf (Página 124)

124/164

S15 Camera Manual: Operating the Camera

www.mobotix.com • [email protected]

3.3 Adjusting Lens Focus and Inserting a Filter

3.3.1 Adjusting Lens Focus (L65-L76/L135-L160 Only)

Once the camera has been installed, the L76 and L160 sensor modules should be checked

for proper image sharpness and manually adjusted, if required. To do so, use the blue

lens wrench and the black module wrench (both are supplied with the S15 basic module).

Procedure

1. Position the blue lens wrench on the notches of

the sensor module. Rotate the wrench to the left

until you feel a stop (max. 300°) and then a little

bit further until the protective glass lens slides out

of the sensor module.

2. Adjust the image sharpness according to the

camera’s live image on the computer monitor. To

do so, position the black module wrench (with the

ring-pattern side) on the lens and carefully rotate

to the right or left.

Do not turn the lens too far or

with force to avoid damaging the image sensor.

3. If required, clean the inside of the protective glass

lens using a clean, lint-free cotton cloth.

4. Place the protective glass lens on the notches of

the blue lens wrench.

5. Position the protective glass lens with its clips

over the two receptacles on the sensor module

(red arrow on the image in the margin) and ﬁrmly

press onto the sensor module. Rotate the glass

to the right using the blue lens wrench until you

feel a stop.

6. If required, clean the outside of the protective glass lens using a clean, lint-free

cotton cloth.

The focusing aid provides a visual aid when correcting the image sharpness (see

The Live

Screen of the MOBOTIX Camera

in the camera’s online help).

M.7

M.8

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 163 164

Sem comentários

Mobotix S15 Especificações Página 124