
3.6 Starting the Camera Using the Factory IP Address
Under certain circumstances, you may have to reset the camera to its factory IP
address. This could be the case if the IP address of the camera has been lost or the
camera does not react to the last known IP address.
Proceed as follows to start the camera using its factory IP address:
• If the camera is powered on, disconnect the power supply of the camera by
unplugging the corresponding cable.
• Connect the camera's power supply.
• Wait until both LEDs are lighting up simultaneously for the first time.
• Press the "L" key on the back of the camera within four seconds.
• After about two more seconds, the camera plays a sound ("Boing").
The camera is now accessible again using its factory IP address (see label on
the camera housing).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
49/56
M22M Camera Manual Part 1
Passwords and camera
settings will not be
changed!
Make sure you store the
factory network
configuration to the
permanent flash memory
Users and passwords will
not be changed!
Note
If you use the camera's "L" key to load the factory network configura-
tion, this configuration is not automatically saved to flash memory.
Upon restarting the camera the next time without using the camera's
"L" key, the
last stored network configuration
will be used. To perma-
nently store the new network configuration in the camera's flash mem-
ory, open Admin Menu > Store ...
Caution
As opposed to resetting the camera using
Admin Menu > Reset
configuration to factory defaults
(see section 1.4.5), the users and
passwords defined in the camera will
not
be reset if the camera is
being booted using the factory IP address.
Press "L" key
"L" key
Comentários a estes Manuais