Mobotix D12 Informações Técnicas descarregar pdf (Página 48)

2.7 Mounting the Casing to a Wall or Ceiling, Connecting the

Cables

2.7.1 Drilling the Holes for the Fixtures Using the Supplied Drilling Template

In order to affix the camera to a ceiling or wall, holes need to be drilled. Use the

supplied

drilling template

to mark the position of the holes for the fixtures and the

holes through which the cables will be led later on. Remember to position the

drilling template according to the direction of the camera's PIR sensor.

2.7.2 Planning and Connecting the CAT5 Cables

(1) Position the camera casing over the cable exit.

(2) Lead the cables through the appropriate holes in the casing.

(3) Properly lead the cable(s) through the cable guides at the outer rim of the

casing.

(4) Use corresponding screws to mount the camera casing to the wall or ceiling.

www.mobotix.com • [email protected] • 23.11.2006

46/96

D12 Camera Manual Part 1

Find the folded drilling

template at the end of

the manual!

Make sure that the

drilling template is not

scaled down when printing!

Note

Make sure that the cable length is appropriate.

Check the following figure to see how the cables

are running properly. Cable length should be

50cm when mounting the D12 and 70cm when

mounting the D12D with Outdoor wall mount,

always measured from the wall. There are two

ways to accommodate cable that is too long (see

figures):

(1) Loop near the RJ45

connectors

(2) Loop beneath the

camera

(1)

(2)

120°

R=75mm

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

Sem comentários

Mobotix D12 Informações Técnicas Página 48